Now it is time to further customize our trailer with unique touches and striking. How about a pair in the tail strobe and neon in the end? Once we have the bulbs, it is the work of wiring, and then integrate them into the piece we are going to use as a lamp, and then install the structure.
For neon tip, we used the indicator light of a cellular base car and joined the reinforcement structure in the connector arm trailer. 
After installing the cable system, tests are performed with the flow of energy which is received from a cell phone. Since consumption of these bulbs is low, the autonomy of the system is extensive. 
And so is this spectacular project, if you want to see this trailer rolled visit RC's blog, meanwhile we will continue putting the finishing touches to the bodywork.
seats were painted in beige. the wheels were good size but the width was excessive, so I had to cut 20% of the wheel with the motor tool to enter into the tiny fender. 
still is pending the restoration of the rest of the interior, set of tires, front bomp, rudder or steering wheel, sound installation, exhaust and of course the rally lines on the hood. 
The installation of the wheels is not yet complete, it needs to be done some adjustments, HOWEVER, despite not being approved to roll yet, gracefully debuted on 27 October at the racetrack Tocancipá the eyes of hundreds of spectators. 
materials so far used are wood, sheet metal, wire mesh, tool motor, blade and patience. You be the judge. 
the trailer will soon paint, stickers club officials, wheels and other small details to try to get ready for its debut Oct. 27 at the racetrack Tocancipá. 
